Power in Flux

What's on your mind?


[140]

Live Feed

Muiren updated their status.
" Is there a Fast Charge mod for a 2013 ZERP S ZF 11.3? "

4 Hours Ago

Spoonman clicked Likes for this post: Honda C50 conversion by supercub50

6 Hours Ago

Richard230 clicked Likes for this post: Honda C50 conversion by supercub50

8 Hours Ago

supercub50 replied to the thread Honda C50 conversion.
" Got the controller and the cable throttle mounted on a mock-up plate, and found an old 48V battery for testing. The throttle cable is a bit short still, hah.

But it works! Very happy now, finally some dynamic on this project. Though I have no experience with other controllers, but still I must say the Nucular is amazing. Very easy to set-up even for a beginner like me.

My BMS, cell holders, DC-DC arrived this week, and I found un-used but cheap INR18650-35E cells for my actual battery. So that's what's coming up next https://uploads.tapatalk-cdn.com/202...57340e914b.jpghttps://uploads.tapatalk-cdn.com/202...7b1b64caf7.jpghttps://uploads.tapatalk-cdn.com/202...17084b64c6.jpghttps://uploads.tapatalk-cdn.com/202...5885019e6c.jpg

Gesendet von meinem FP3 mit Tapatalk "

8 Hours Ago

flo replied to the thread Kawasaki zxr-E.
" Hi,
after the new crimp connectors arrived finally saturday evening (so much for ships overnight) i was set to tackle the last cell.
first of, a last mock-up topplate was milled from scrap to check the sit of the e-stop in relation to that last cell.
Attachment 8585

No more excuses.

This is where all has to go on to:
Attachment 8587

Place the last cell on top but set slightly back from bus bar to avoid shorts during the next step:
Attachment 8586

attache sens wires and don`t get confused, as there is now no visual with the underlying cell:
Attachment 8588

slide cell forwards and connect with the rest of the pack, put on fiberglass protectors, which mainly serve to prevent shorting when getting the pack into the bike-frame.
As can be seen the left one was milled to the wrong sice
Attachment 8589
cannot be bothered tonight, gonna cut it tomorrow, will connect up the e-stop then too.

Stay tuned "

3 Days Ago

jhaggerty replied to the thread Zero 75-5 Motor.
" Zero motor is sold. ME motor and Kelly are still available and batteries are still available. "

4 Days Ago

supercub50 clicked Likes for this post: Kawasaki zxr-E by flo

4 Days Ago

supercub50 clicked Likes for this post: Kawasaki zxr-E by flo

4 Days Ago

jordan325ic replied to the thread Hello and....Hi Folks, New to the forum, planning to convert a 77 Triumph Tiger to.
" Have you tried to contact them? I tried a few times 6 months ago and got no response, also no response from a vendor. QS motor / saiecosys on aliexpress also make high power hub motors (not thru-bolt though) "

5 Days Ago

Stevo clicked Likes for this post: Kawasaki zxr-E by flo

1 Week Ago

Stevo replied to the thread QuantumScape solid state battery breakthrough article.
" Shitsters!
When will we get our next gen batts?!!! (Its OK I only have 68 charge cycles on mine... Ive got years to wait!!) "

1 Week Ago

Stevo clicked Likes for this post: QuantumScape solid state battery breakthrough article by Richard230

1 Week Ago

Stevo clicked Likes for this post: QuantumScape solid state battery breakthrough article by Warren

1 Week Ago

flo replied to the thread Kawasaki zxr-E.
" Hi Stevo,

yup thatīs the plan
Well actually the plan had been to fabricate all Parts and modules during christmas hollidays. Ready to be installed late winter early spring - we want to ride as much as possible don`t we?
Plan fell through as i got stalled again
I have crimping connectors here 35mm2 for m6 but the things fall of the cable after crimping them... rechecked with an 35mm2 M8 and it stays on rock solid.
Anyway found some that will hopefully fit, should be here by tomorrow.

As work started again progress will slow down naturally.
Nothing to worry - got 90% done within my planning. And winter just started..
Hope to have the batterie module done next by next weekend.
So stay tuned

Flo "

1 Week Ago

tylerwatts clicked Likes for this post: Kawasaki zxr-E by flo

1 Week Ago

Richard230 replied to the thread QuantumScape solid state battery breakthrough article.
"
Quote Originally Posted by Warren View Post
Crap! It looks like their batteries might be too good to be true. When will this kind of startup investor screwing ever end? "

1 Week Ago

Stevo replied to the thread QuantumScape solid state battery breakthrough article.
" I saw one yesterday that said the Chinese company NIO will have their SS battery out Q4 2022.
Competition is a good thing!! "

1 Week Ago

Stevo replied to the thread Kawasaki zxr-E.
" You are making fast progress. Maybe you will have it on the road before the snow melts LOL "

1 Week Ago

Richard230 created the thread QuantumScape solid state battery breakthrough article.
" Here is an interesting article that was in my newspaper yesterday regarding QuantumScape's new solid-state EV battery design. Unlike previous announcements regarding such batteries, this one looks like it will be going into production as it is apparently backed by Volkswagen. The QuantumScape's plan is to put their new battery into volume production and into VW EVs by 2025. "

1 Week Ago