Power in Flux

What's on your mind?


[140]

Live Feed

EVcycle replied to the thread Wire Sizing for Motorcycle Conversion.
" PM sent.

Ed "

5 Hours Ago

supercub50 clicked Likes for this post: Kawasaki zxr-E by flo

8 Hours Ago

flo replied to the thread Kawasaki zxr-E.
" ..I have completed the battery box.
Like this the whole assembly can be put into the bike without any wires "life".
Attachment 8590
Attachment 8591
Attachment 8592
The two red lines with fuse holders will connect to charger and dc/dc.

Also had a first go at the wiring scheme.
Some of you will find this familiar .. it s actually just a revised version of my sachs`s scheme.
The principle should be the same, only the connectors might need some redo.
Anyone care to have a look at it?

Attachment 8593

stay tuned

Flo "

12 Hours Ago

Stevo clicked Likes for this post: Honda C50 conversion by supercub50

1 Day Ago

Stevo replied to the thread The Curtiss One has arrived.
" I see steam punk
https://youtu.be/Nbq6Wfh9fi4 "

1 Day Ago

Richard230 created the thread The Curtiss One has arrived.
" Get yours now before they sell out. https://electricmotorcycles.news/cur...rvations-open/

Kind of reminds me of the mid-1970's Sachs Wankel rotary-powered motorcycle. "

1 Day Ago

Muiren updated their status.
" Is there a Fast Charge mod for a 2013 ZERP S ZF 11.3? "

2 Days Ago

Spoonman clicked Likes for this post: Honda C50 conversion by supercub50

2 Days Ago

Richard230 clicked Likes for this post: Honda C50 conversion by supercub50

2 Days Ago

supercub50 replied to the thread Honda C50 conversion.
" Got the controller and the cable throttle mounted on a mock-up plate, and found an old 48V battery for testing. The throttle cable is a bit short still, hah.

But it works! Very happy now, finally some dynamic on this project. Though I have no experience with other controllers, but still I must say the Nucular is amazing. Very easy to set-up even for a beginner like me.

My BMS, cell holders, DC-DC arrived this week, and I found un-used but cheap INR18650-35E cells for my actual battery. So that's what's coming up next https://uploads.tapatalk-cdn.com/202...57340e914b.jpghttps://uploads.tapatalk-cdn.com/202...7b1b64caf7.jpghttps://uploads.tapatalk-cdn.com/202...17084b64c6.jpghttps://uploads.tapatalk-cdn.com/202...5885019e6c.jpg

Gesendet von meinem FP3 mit Tapatalk "

2 Days Ago

flo replied to the thread Kawasaki zxr-E.
" Hi,
after the new crimp connectors arrived finally saturday evening (so much for ships overnight) i was set to tackle the last cell.
first of, a last mock-up topplate was milled from scrap to check the sit of the e-stop in relation to that last cell.
Attachment 8585

No more excuses.

This is where all has to go on to:
Attachment 8587

Place the last cell on top but set slightly back from bus bar to avoid shorts during the next step:
Attachment 8586

attache sens wires and don`t get confused, as there is now no visual with the underlying cell:
Attachment 8588

slide cell forwards and connect with the rest of the pack, put on fiberglass protectors, which mainly serve to prevent shorting when getting the pack into the bike-frame.
As can be seen the left one was milled to the wrong sice
Attachment 8589
cannot be bothered tonight, gonna cut it tomorrow, will connect up the e-stop then too.

Stay tuned "

5 Days Ago

jhaggerty replied to the thread Zero 75-5 Motor.
" Zero motor is sold. ME motor and Kelly are still available and batteries are still available. "

6 Days Ago

supercub50 clicked Likes for this post: Kawasaki zxr-E by flo

6 Days Ago

supercub50 clicked Likes for this post: Kawasaki zxr-E by flo

6 Days Ago

jordan325ic replied to the thread Hello and....Hi Folks, New to the forum, planning to convert a 77 Triumph Tiger to.
" Have you tried to contact them? I tried a few times 6 months ago and got no response, also no response from a vendor. QS motor / saiecosys on aliexpress also make high power hub motors (not thru-bolt though) "

1 Week Ago

Stevo clicked Likes for this post: Kawasaki zxr-E by flo

1 Week Ago

Stevo replied to the thread QuantumScape solid state battery breakthrough article.
" Shitsters!
When will we get our next gen batts?!!! (Its OK I only have 68 charge cycles on mine... Ive got years to wait!!) "

1 Week Ago

Stevo clicked Likes for this post: QuantumScape solid state battery breakthrough article by Richard230

1 Week Ago

Stevo clicked Likes for this post: QuantumScape solid state battery breakthrough article by Warren

1 Week Ago

flo replied to the thread Kawasaki zxr-E.
" Hi Stevo,

yup thatīs the plan
Well actually the plan had been to fabricate all Parts and modules during christmas hollidays. Ready to be installed late winter early spring - we want to ride as much as possible don`t we?
Plan fell through as i got stalled again
I have crimping connectors here 35mm2 for m6 but the things fall of the cable after crimping them... rechecked with an 35mm2 M8 and it stays on rock solid.
Anyway found some that will hopefully fit, should be here by tomorrow.

As work started again progress will slow down naturally.
Nothing to worry - got 90% done within my planning. And winter just started..
Hope to have the batterie module done next by next weekend.
So stay tuned

Flo "

1 Week Ago