Power in Flux

Search:

Type: Posts; User: larkmachineco

Search: Search took 0.00 seconds.

  1. Replies
    120
    Views
    27,128

    Looks Good!!!! Those are some thick busbars!!!! ...

    Looks Good!!!! Those are some thick busbars!!!! I might recommend using some dielectric grease to fill any spots under the busbar. it helps in the long run
  2. Replies
    25
    Views
    6,320

    I have been lagging on updating the project. But...

    I have been lagging on updating the project.
    But you guys migh tlike this if you haven't seen it yet!

    https://youtu.be/1BoWQ54NpU0https://youtu.be/1BoWQ54NpU0

    <iframe width="560" height="315"...
  3. Replies
    25
    Views
    6,320

    https://youtu.be/K5UyxOfL5nM...

    https://youtu.be/K5UyxOfL5nM https://youtu.be/K5UyxOfL5nM

    <iframe width="560" height="315" src="https://www.youtube.com/embed/K5UyxOfL5nM" frameborder="0" allow="accelerometer; autoplay;...
  4. Replies
    25
    Views
    6,320

    https://youtu.be/1BoWQ54NpU0

    https://youtu.be/1BoWQ54NpU0
  5. Replies
    25
    Views
    6,320

    81618162 Would this make everyone feel better?...

    81618162

    Would this make everyone feel better?
    I scavenged an old project for these eval board.
    I still need to make them work and build a holder for them
  6. Replies
    25
    Views
    6,320

    Thanks for the support. I'm not against a BMS,...

    Thanks for the support. I'm not against a BMS, Im just focused on the essentials, and a BMS is low on the essential list right now. If I can get funding or if it proves to be essential, I will add...
  7. Replies
    25
    Views
    6,320

    You wanna sponsor me and send one of yours?!?!?!?

    You wanna sponsor me and send one of yours?!?!?!?
  8. Replies
    25
    Views
    6,320

    Actually, i have to be able to get out of the...

    Actually, i have to be able to get out of the bike within seconds. You have to perform it at tech. The rules also require you to have 6 lbs of coldfire in the driver compartment. The safety aspect...
  9. Replies
    25
    Views
    6,320

    I dont ever plan on leaving the vehicle during...

    I dont ever plan on leaving the vehicle during charging, I have a Manzanita 50A charger. I was planning on having a 1 ohm power resistor on board so I can leak down out of balance cells on the fly. ...
  10. Replies
    25
    Views
    6,320

    Hey there, unfortunately, I can't share the motor...

    Hey there, unfortunately, I can't share the motor type or code.
    But, the arduino is much faster than the motor signal. I am not a software engineer, but I do understand your concern. I got a...
  11. Replies
    25
    Views
    6,320

    I will have individual cell monitors, but I will...

    I will have individual cell monitors, but I will not have any balancing, or charge control. ...
  12. Replies
    25
    Views
    6,320

    When I first got the batteries, I did not know...

    When I first got the batteries, I did not know what they were. They were free and that was the main selling point.
    I capacity tested them and the built a discharge rig to test the voltage drop and...
  13. Replies
    25
    Views
    6,320

    Lark Streamliner EV motorcycle Project

    8138
    8139
    8140
    Hello,
    I am new to the forum and it was suggested that I post on this forum to share my project with the EV motorcycle community.
    I would love to hear from you guys about your...
Results 1 to 13 of 13